An Omega Speedmaster 63130 copy is a first copy replica of the Moonwatch style chronograph that sellers list under the 63130 product code. That code is a catalog label rather than a spec sheet, so the watch you receive depends on which factory built it and which genuine Speedmaster it was copied from. Judge any 63130 copy on four points: case size, subdial layout, movement type, and crystal.
Omega Speedmaster 63130 Clone Watch: Buyer's Guide
What is an Omega Speedmaster 63130 copy?
It is a first copy watch, meaning a replica built to match the look and feel of the Speedmaster chronograph listed under the 63130 code in online catalogs. Sellers market this tier as the top level of replica, with a clone chronograph movement, a sapphire or hesalite style crystal, and a steel bracelet that mimics the original end links. The 63130 label stays a listing code, so confirm the source reference before you compare specifications.
Which real Speedmaster does the 63130 code match?
Ask the seller which genuine reference the 63130 copy is based on, because the Moonwatch family spans models with very different dials and movements. The classic Professional Moonwatch uses a 42 mm case, a 20 mm lug width, and a manual wind chronograph with subdials at 3, 6, and 9 o'clock. Reduced and automatic variants use smaller cases and different subdial spacing, and copies of those are easier to get wrong.
What should you check on a first copy Speedmaster?
Case and crystal
The case should measure about 42 mm across, excluding the crown and pushers, with lugs that match the source reference. Crystal choice matters: hesalite has a warm dome and soft reflections, while sapphire is flatter and clearer. A copy with heavy edge distortion reads as fake from across a table.
Fake Omega Speedmaster 63130: How to Spot One Before You Pay
Dial and subdials
Check subdial position first, since spacing is the quickest tell on any Speedmaster copy. On a Moonwatch style dial the running seconds sits at 9 o'clock, the 30 minute counter at 3, and the 12 hour counter at 6, with no date window. Print quality, the step or flat dial edge, and the tachymeter scale all need to line up with the reference you are comparing.
Movement and pushers
A manual wind clone movement keeps the slim profile and the correct subdial layout, while many cheap copies hide an automatic movement behind a decorated plate. Press the pushers: a good chronograph starts, stops, and resets with a clean click, and the seconds hand snaps back to zero. If the pushers feel mushy or the reset hand lands off center, the movement is the weak point.
Bracelet and clasp
Original style bracelets taper from the lugs and use solid end links that sit flush against the case. Look at the clasp engraving, the number of removable links, and the fit at the lug line. A rattling bracelet with hollow links is the second most common giveaway after the dial.
How do you spot a low grade copy?
- A date window on a dial that should have none
- Subdials at 6, 9, and 12 instead of 3, 6, and 9
- A quartz movement with a ticking seconds hand
- Wrong case diameter, often 40 mm or smaller
- Plastic crystal with distortion at the edges
Frequently asked questions
Is a first copy Speedmaster 63130 worth buying?
It can be, if the seller shows photos of the exact watch and the specs line up with a known reference. Buy for the look and the mechanics rather than resale value, since first copy watches do not hold value like genuine pieces.
What is a fair price for a first copy Speedmaster?
Prices track movement type and finishing. Quartz copies sit at the bottom, automatic mid grade copies in the middle, and manual wind clones with sapphire crystal at the top of the first copy range. Compare three sellers with the same spec sheet before you commit.
Are first copy Speedmasters water resistant?
Treat any water resistance claim as unverified unless the seller states a tested rating and a gasket seal. Splash resistance is realistic, swimming and diving are not. Have a local watchmaker pressure test the case before you wear it near water.